Uniden EXAI 6980 Receiving calls

Handset ringer tone

In the standby mode, press or .

Each time or is pressed, the ringer

tone setting changes and the selected ringer tone

sounds for 2 seconds.

Handset earpiece volume

During a telephone call, pressing or will change the earpiece volume of

the handset. This setting will remain in effect after the telephone call has ended.

When you press in Loud mode or press in Normal mode, an error

tone sounds.

Receiving calls (continued)

EXAI 6980 2nd HEN 10/31/00 10:06 AM Page 17

Contents

Main Introduction Features Table of contents Getting Started Basics Telephone Features Caller ID Features Step 1 Step 2 Step 3 Step 4 About the digital security code Step 1 Checking the package contents Uniden Parts Department Step 2 Setting up the base unit Choose the best location Page Step 2 Choose the dialing mode Page Step 3 Battery use time (per charge) When the battery charge becomes low Cleaning the battery contacts Page Page Page Page Page Receiving calls 1 2 3 Receiving a call from the handset Auto Talk when ringing Any key when ringing Receiving calls Page Page 4 Memory storing 5 6 7 Memory dialing Making calls with memory dialing Dialing from standby 2 1 3 Page Page Memory editing 7 8 9 Display a Programmed Number Page Page Caller ID Features When the telephone rings 1 2 Caller ID Features Viewing the Caller ID Message list 1 2 3 4 Page Page Page Page Page Page Page 1 2 Turning the answering machine on and off 2 : 2 times 4 : 4 times TS :In the TS (toll saver) position, if you Setting the number of rings Setting maximum recording time for incoming messages Page Deleting recorded messages 1 2 AT THE HANDSET AT THE BASE Page Page Page 1 2 3 4 5 6 * Page Page Page Direct wall plate mounting 1 2 8 9 Installing the beltclip To attach the beltclip To remove the beltclip Headset installation Note on power sources Battery replacement and handling RECYCLING NICKEL-CADMIUM BATTERIES Power Failure Ni-Cd Troubleshooting Page 1-800-297-1023 Index 0 - 9 A B C