1Call your telephone number.
2While the greeting message plays, press #and your PIN code. If the answering
machine is off, let it ring 10 times until the greeting message plays.
Then, press #and your PIN code.
3The answering system announces the time and day stamp and the number of mes-
sages stored in memory. Then the Message playback automatically begins.
4You may continue to listen to your messages or you may select a command from
the following chart:
5After all of your messages have played, or the playback time exceeds 4 minutes,
you will hear intermittent tones indicating that the system is in the command wait-
ing mode. You may enter another command at this time from the chart above.
6When you are finished, hang up to exit the system. The answering system
automatically returns to standby.
Command Function
#then 1Repeat
#then 2Playing your messages
#then 3Skipping a message
#then 4Deleting a message
#then 5Stop message playback
#then 6Answering system on
#then 7Voice memo record/stop
(up to 4 minute recording time)
#then 8Greeting message record/stop
#then 9Answering system off
#then Room monitor
43
Using the answering machine (continued)
Remote access away from home
You can operate your answering system from a remote location using any touch-tone
telephone. Use this function to check for recorded messages, to play or delete
messages, even to record a new outgoing message, and to monitor sounds in the
room.
*
Notes
•During the remote operation, rC displays on the base.
•You must enter a command within 15 seconds of entering the command waiting
mode or the answering system automatically hangs up and returns to standby.
•The system will only play back messages for four minutes and then it returns to the
command waiting mode. To continue playing your message, press #then 2again
within 15 seconds
EXAI 6980 2nd HEN 10/31/00 10:06 AM Page 43