Mounting the Base Unit on a Wall
Setting the handset retainer clip for wall mounting
1) On the base unit, pull the handset retainer clip out of the slot and rotate it clockwise 180 degrees.
2) Flip the retainer clip from front to back. Slide it back into the slot so that the lip of the retainer is up and the ▼ is down. The retainer holds the handset in place.
Standard wall plate mounting
This phone can be mounted on any standard wall plate.
1) Snap the wall mount adapter into the notches on the base bottom.
2) Plug the AC adapter to the DC IN 9V jack.
3) Route the AC adapter cord through the molded wiring channel as shown.
4) Plug the AC adapter into a standard 120V AC wall outlet.
5) Plug the telephone line cord into the TEL LINE jack. Route the cord through the molded wiring channel as shown.
6) Plug the telephone line cord into the telephone outlet. 
7) Raise the antenna to a vertical position.
8) Align the mounting slots on the base with the mounting posts on the wall. Then push in and down until the phone is firmly seated.
!
DO NOT use an outlet controlled by a wall switch.
GETTING STARTED
www.uniden.com | G E T T I N G S TA R T E D [ 13 ] |
