English - 20

Installing a Line Filter or DSL Filter

A telephone line filter or DSL filter pre vents services t hat use the phone line
from causing interference on your phone. To get a line f ilter, contact your
service provider or look in an elec tronics store.
Plug the filter into the telephone wa ll jack and plug the base i nto the filter.
Make a test call to make su re the noise is gone.

Liquid Damage

CAUTION: If the base is covered in liquid, d isconnect the adapt er &
phone cord from the wall before touch ing it.
If the liquid is only on the exter ior housing of the base or hand set, wipe it off
and use as normal. If you can hea r liquid inside the housi ng:
1. R emove all compartme nt covers, and disconnec t all cables and cords .
2. I f liquid is leaki ng from any vent or hole, turn t he phone so that the vent
faces down. If not, place the large st vent face down.
3. L et dry for at least 3 days . Check for liquid inside th e phone before replacing
compartment covers & reconnecti ng cords.

Resetting Stations

Unplug the base to reset it. Plug it back in af ter at least a minute.
If you have trouble with a handset or if you w ant to replace one, reset it.
1. P ress & hold
End
and

#

at the same time until you see t he
System Reset
menu.
2. I f you still have the bas e the handset is regi stered to, select
Deregister
HS
, then select the handset you wa nt to reset. If you don’t have that base
anymore, select
Base Unavailable
.
3. To conf irm, select
Yes
. The handset displays
Handset not regi stered
.

Registering Handsets

If you see
Not Registered
on a handset, you must register it to a bas e before use.
1. Pl ace the handset in t he base; the display shou ld say
Registering
. If the
handset does not fit in the bas e, open the base menu and selec t
Register Accy
.
On the handset, press and hold
#
until
Registering
displays.
2. Wait u ntil the display says
Registration Co mplete
(about 30 seconds), then
pick up the handset and press
Talk/Flash
.
#If you don’t hear a dial tone or the display says
Registration Failed
,
charge the battery completel y, then try again.