Uniden XSA660 manual Installing the Battery Pack, Replace the battery cover, Charging the Handset

The battery connector will fit together only one way. Make sure the connector is properly aligned. Use only the Uniden battery pack (model BT-434)

Replace the handset on the base after use if convenient. However recharging the battery is only necessary when the low battery indicator is lit. On a monthly basis use the phone until the low battery indicator appears. Then charge the battery for 15-20 hours.

Installing the Battery Pack

The rechargeable Nickel-Cadmium battery pack must be fully charged before using your phone for the first time. Before plugging the phone line into your new phone, you must charge the battery for approximately 15-20 hours without interruption.

1.Remove the Handset battery cover.

2.Plug the battery’s cable into the handset and place the battery pack inside the battery compartment.

3.Replace the battery cover.

Charging the Handset

1.Place the handset on the base to charge. (The handset will charge only in the face-down position.) OR place the handset on the charger keypad facing forward (XSA660 only).

(Spare Handset - XSA660 only)

2.Make sure the status LED lights on the base or change LED lights on the charger. If the LED doesn’t light, check to see that the AC Adaptor is plugged in and switched on. Also that the Handset is making good contact with the Base Unit and charger charging contacts.

Continuous Battery Charging

For the best battery performance, return the Handset to the Base Unit at the end of the day. This keeps the battery fully charged.

12