Uniden XSA660, XSA650 manual Troubleshooting, Trouble Shooting

TROUBLESHOOTING YOUR NEW PHONE

TROUBLE SHOOTING

If your XSA660 or XSA650 Integrated Telephone Answering Device is not performing to your expectations, please try these simple steps. If you are still unable to resolve the problems, contact Uniden Customer Service for assistance.

Caution: Do not attempt to service this until yourself. Servicing must be performed by qualified personnel.

PROBLEM		SUGGESTION
	●	Make sure the AC adaptor is plugged into the base and
Charge light won’t		wall outlet.
come on when	●	Make sure the handset is properly seated in base.
handset is placed	●	Make sure the charging contacts on the handset and base
in base.
		are clean. See page 14
	●	Make sure that the base antenna is fully extended in the
		vertical position.
The audio sounds	●	Interference by other electronics equipment such as TVs.
weak and/or
		Computers microwaves etc.
scratchy.
	●	You may have gone too far from the base.
	●	Press the chan key to search for clearer reception.
	●	Check both ends of the base telephone line cord are
		plugged in fully.
	●	Make sure the AC adaptor is plugged into the base and
Can’t make or		wall outlet.
	●	Disconnect the AC adaptor for a few minutes, then
receive calls.
		reconnect it.
	●	Reset security code by placing the handset back on the
		base for a few seconds. The status LED will blink
		indicating that the phone has been reset.
	●	The Nickel-Cadmium battery pack may be weak.
		Charge the battery for 15-20 hours.
The handset	●	The handset may be too far away from the base.
		Place the base away from appliances or metal objects.
doesn’t ring or	●
		Reset security code by placing the handset back on the
receive a page.	●
		charging cradle for a few seconds. The status LED will
		blink indicating that the phone has been reset.

28