Chapter 4 Terminal Interface
4.1Installation
To install the scanner as a terminal interface, you need a DB25 RS232 cable, a terminal wedge “Y” cable and an AC adapter. See Figure 3 for reference.
Original Cable
Terminal
male
female
"Y" Cable | SCANNER |
Host
AC adaptor
RS232 Cable
Figure 3. Installing as a Terminal Wedge
Installation procedures:
1)Power off the terminal and unplug the communication cable at terminal side.
2)Install the interface cable as shown in Figure 3. The “Y” cable provided in Figure 3 is for terminals with female connector on communication port. If there is a male connector on your terminal, you need a converter to change that male to female and another converter to change the female to male on host connector.
3)When the scanner is powered, a long beep sound indicates that the scanner is ready to use.
Page 11
