Chapter 5 Wand Emulation

5.1Installation

Figure 4 shows how a wand emulation scanner is installed to a data collection terminal. User needs to pay attention to the scanner pinout that should be the same as specified by the terminal.

SCANNER

Figure 4. Installed as a Wand Emulation Scanner

5.2Understanding the Operating Parameters

Code 39 Output:

When device number “07” is selected, the scanner is set as wand emulation with Code 39 output. In this configuration, the scanner always outputs data with Code 39 symbology no matter what symbology of the label it scans. You may scan the following label if this setting matched your application.

Code39 Wand

Emulation

Native Output:

When device number “26” is selected, the scanner is set to wand emulation with native output. That means the scanner outputs data with both the same contents and symbology as the label represents.

Page 13

Page 14
Image 14
Unitech Hand Held Scanner user manual Wand Emulation, Code 39 Output, Native Output