Universal Remote Control RF10 manual Erasing Commands Overview, Displayed on the LCD screen

27					28
Commands- Overview	Erasing Commands – Overview				ErasingCommands
	RF10 to its original factory default settings.
	You can erase a single command, all learned commands in
	each component mode, SimpleSound™ commands or
	MacroPower™ commands.
	If you really want a fresh start, it is possible to reset the
Erasing
	Erasing One Learned Command
		STEP 1:		STEP 2:
		Press and hold both the		Press and hold the button you
		COMPONENT button where the		want to erase for 2 seconds.
		command is stored and the ENT		The display will flash ERASE
				twice, then display LEARN.
		(Enter) button at the same time
		for approximately 3 seconds,
COMMANDSERASING		until the word “LEARN” is			ERASINGCOMMANDS
		displayed on the LCD screen.
		IMPORTANT:You now have 30 seconds to
		perform the next step while you are in
		LEARN mode. If you don’t press a button
		within 30 seconds, LEARN will disappear
		from the screen, signaling that you have
		exited erase mode and you will need to
		start over.		Repeat this step to erase any
				other buttons in the same mode.
				STEP 3:
			COMPONENT
			COMPONENT	To save, press and hold the
			BUTTONS	COMPONENT button and the
			ENT	ENT button until the word
			ENT	“SAVED” flashes twice on the
			BUTTONS
				LCD screen. The RF10 will then
				automatically return to normal
				operating mode.