Universal Remote Control RF10 manual Control Locations, Getting Started-Overview

3

Keypad Layout

CONTROL LOCATIONS

Getting Started-Overview

This is what MASTERCONTROL™ RF10 is all about!

The RF10 is designed to operate up to 8 different Audio/Video Components and is pre-programmed to operate virtually all brands of TV, VCR, DVD and CD Players, Cable Set Top Boxes, Satellite Receivers, TiVo and other DVRs, Audio Components, Tape Decks, Multimedia PCs, XM Radio, Ipod, X-Box, Lighting Controls and other custom installation products. It also offers an impressive lineup of special features designed to provide you with many time-saving conveniences and enhance your overall entertainment experience. However, we strongly recommend that you fully complete all of the Basic Setup steps before proceeding to customize your RF10 with any of the special advanced features.

Battery Installation
The very first step is to insert
the four AAA batteries that	-
are included in the package		+
into the battery compartment
located in the back of the	+
remote. Just press the tab		-
and lift off the cover. Please
be sure to insert the batteries	-
		+
correctly as you see in the
diagram. Remember, there
is a positive and negative	+	-
end to each battery and you
can tell by the + (positive) and
– (negative) symbols. Once
the batteries are correctly
installed, replace the cover.
Now you’re ready to start!

4

Overview & Battery Installation

GETTING STARTED