35
Recalling
Recalling Pre-Programmed Setup Code Numbers
In case you didn’t write down the
Cloning Other RF30s
If you are fortunate enough to own more than one RF30, you’ll be happy to know that you can easily copy and transfer all the setup from one RF30 to another. Just follow these easy steps:
36
Cloning Other RF30s
STEP 1:
Press and hold the MAIN and ENT (Enter) buttons at the same time for approximately 3 seconds, until the word “SETUP” is displayed at the top of the LCD touch screen. This signals that you are now in setup mode.
STEP 3:
Write down the code numbers as they appear for future reference. Page 43 of this manual provides a convenient space for you to record your code numbers.
STEP 1:
For both the programmed RF30 that you want to clone, and unprogrammed RF30, press and hold the MAIN and ENT (Enter) buttons at the same time for approximately 3 seconds, until the word “SETUP” is displayed
STEP 3:
Press the CLONE button on each remote.
IMPORTANT:You now have 30 seconds to perform the next step while you are in SETUP mode. If you don’t press a button within 30 seconds, SETUP will disappear from the screen, signaling that you have exited setup mode and you will need to start over.
STEP 4:
Return to normal operation by pressing the MAIN button twice.
at the top of their respective LCD touch screens. This signals that both remotes are now in setup mode.
IMPORTANT:You now have 30 seconds to perform the next step while you are in
CUSTOMIZING
STEP 2:
Press the RECAL button on the LCD screen. Each of the four screen pages will display the Component name and its corresponding code number.
NOTE: Use the (
or 
) page buttons to display any of the four pages of Components and their code numbers.
SETUP mode. If you don’t press a button within 30 seconds, SETUP will disappear from the screen, signaling that you have exited setup mode and you will need to start over.
STEP 2:
Press a PAGE button on each remote to bring up Page 2 of Setup and display the CLONE button.
