Vanguard Heating Direct-Ventgas Fireplace, VDDVF36PN/PP and VDDVF36STN/STP Series, Continued

® DIRECT-VENT GAS FIREPLACE

VDDVF36PN/PP and VDDVF36STN/STP Series

OPERATING

FIREPLACE

Continued

OPTIONAL REMOTE

OPERATION

Note: All remote control accessories must be purchased separately (see Accessories, page 28). Follow instructions included with the remote control.

NOTICE: You must light the pilot before using the hand-held re- mote control unit. See Lighting Instructions, column 2.

Piezo Ignitor Pilot Burner

Thermocouple

Thermopile

Figure 51 - Pilot

1.After lighting, let pilot flame burn for about one minute. Turn control knob to ON position. Adjust flame adjust- ment knob anywhere between HI and LO. Slide the selector switch to the REMOTE position. Note: The burn- ers may light if hand-held remote ON button was on when selector switch was last turned off. You can now turn the burners on and off with the hand- held remote control unit.

IMPORTANT: Do not leave the se- lector switch in the REMOTE posi- tion when the pilot is not lit. This will drain the battery.

IMPORTANT: Be sure to press the ON/OFF buttons on the hand-held remote control unit for up to 3 sec- onds to assure proper operation.

GHRC Operation:

2a. Press ON/OFF button to turn the burners on and off. When turning burners off, the pilot will remain lit.

Flame Adjustment Knob

			Control Knob in
IH			On Position
		F	PIL
ON			O
	O	F	T
OFF			O
			N
REMOTE
LO

Selector Switch in Remote Position

(Optional Remote Control)

Figure 52 - Setting the Selector Switch, Control Knob, and Flame Adjustment Knob for Remote Operation

22 106918