TERMINAL SETUP
Connect Optional Device(s)
Connect
Optional
Device(s)
9Close the cardholder by pivoting the cover back to its connector base (see Figure 11).
10Lock each MSAM cardholder by sliding its locking plate, as shown by the LOCK arrow, until the plate stops (see Figure 10).
11Replace the MSAM compartment door and reinstall the locking screw (see Figure 9).
The Omni 37xx supports some peripheral devices designed for use with electronic
Use the two ports on the back panel to connect up to two optional devices.
CAUTION Before connecting any peripheral device, remove the power cord from the back of the terminal and be sure the LED is not lit. Reconnect the power cord only after you are finished connecting the peripheral device(s). For complete information about peripheral installation and use, refer to the user documentation supplied with those devices.
The following sections discuss the most common optional devices supported by this terminal.
Table 2 Optional Devices Supported
Optional Device | Connection Port |
|
|
Barcode | PIN Pad |
CR 600 | RS232 |
Console | PIN Pad |
External LAN | RS232 |
PIN Pad | PIN Pad |
RS232 Electronic Cash Register | RS232 |
|
|
Other optional devices may be supported. For more information, please contact your VeriFone distributor.
NOTE
Connect PIN Pad, Smart Card Reader, or Bar Code Wand
To Connect PIN Pad, Smart Card Reader, or Bar Code Wand
1If necessary, insert the small modular plug on one end of the PIN pad cable into the PIN pad’s modular jack.
For a bar code wand, insert the
2If installing a PINPad 101, PINpad 201 or PINpad 1000, position and insert the grommet to secure the cable connection.
18OMNI 37XX INSTALLATION GUIDE
