VeriFone Omni 37xx manual Smart Card Reader Connection

TERMINAL SETUP

Connect Optional Device(s)

If a cable is not already connected to the smart card reader or PINpad 501, insert the small modular plug on one end of the interface cable into the optional device’s modular jack.

3Insert the larger RJ45-type connector on the other end of the PIN pad cable into the PIN pad serial port on the terminal’s back panel.

Figure 12 provides an example of a Smart Card Reader connection to a Bar code and PIN pad serial port.

Figure 12 Smart Card Reader Connection

Connect Check The Omni 37xx base supports two VeriFone check readers: CR 600 and Reader CR 1000i. Contact your VeriFone representative or visit the online store at

www.verifone.com for information on these devices. Figure 13 provides an example of a peripheral connection to an RS232 port.

CAUTION Check readers require a separate power source. Before connecting a check reader or similar device, remove the power cord from the back of the terminal and be sure the LED is not lit.

OMNI 37XX INSTALLATION GUIDE 19