TERMINAL SETUP
Installing/Replacing SIM Card (GSM/GPRS Models Only)
6Install an MSAM card by aligning the card and carefully sliding it within the guides on the cover until it is fully inserted (see Figure 14). The MSAM card holders are labeled MSAM1, MSAM2, and MSAM3.
Figure 14 Installing MSAM Card
NOTE Before inserting the MSAM card, position it as shown in Figure 14, with the card’s gold contacts facing the smart card reader end of the terminal. The cardholder connector base has a set of contacts and a notch on one corner to ensure the MSAM card is positioned correctly. The MSAM card has a notch on one corner to ensure that it fits into the connector base in only one way. The MSAM compartment door will not close properly if the MSAM cards are installed incorrectly.
Installing/ Replacing SIM Card (GSM/GPRS Models Only)
7Install the battery (see Figure 17).
The Vx670 terminal supports the installation of a SIM (Subscriber Identity Module) card. Use the following procedure to replace or install a SIM card.
1Place the terminal upside down on a soft, clean surface to protect the lens from scratches.
2Remove the battery.
Figure 15 Removing the Smart Battery
3After removing the battery, the SIM compartment is exposed. The SIM card holder is labeled RADIO SIM.
24VX670 INSTALLATION GUIDE
