Vermont Casting 39LDVR, 43LDVR General Venting, LDVR Series Direct Vent Gas Fireplace, 10007317

LDVR Series Direct Vent Gas Fireplace

	BLACK						L1
	WHITE						L2			POWER CORD
					GREEN
	PURPLE								PILOT SENSING
		CLEAR
									PILOT IGNITER
							YELLOW
								M		P
								O		O
											VALVE
CIRCUIT BOARD						BLUE
								ORANGE
				RED					ON/OFF SWITCH
			WHITE							OR
									WALL THERMOSTAT

FP1571

Fig. 9 SIT822 Valve with Synetek electronic control wiring diagram.

General Venting

Your fireplace is approved to be vented either through the side wall, or vertically through the roof.

•Only CFM Corporation venting components specifi- cally approved and labelled for this fireplace may be used.

•Vent terminations shall not be recessed into a wall or siding.

•Horizontal venting which incorporates the twist lock pipe must be installed on a level plane without an inclining or declining slope.

•Horizontal venting which incorporates the use of flex venting shall have an inclining slope from the unit of 1” (25 mm) per 24” (610 mm).

There must not be any obstruction such as bushes, garden sheds, fences, decks or utility buildings within 24” (610mm) from the front of the termination hood.

Do not locate termination hood where excessive snow or ice build up may occur. Be sure to check vent termi- nation area after snow falls, and clear to prevent ac- cidental blockage of venting system. When using snow blowers, make sure snow is not directed towards vent termination area.

Location of Vent Termination

It is imperative the vent termination be located observ- ing the minimum clearances as shown on the next page.

*Check with local codes or in absence of same with CSAB149.1 Installation Codes (1991) for Canada or fol- low the current National Fuel Gas Code, ANSI Z223.1/ NFPA 54 for installations in the USA.

10007317 9