Vermont Casting RHEDV25 Large Lava Rock Placement, Flame Adjustment RN/RP Models, Honeywell Valve

Vermont Castings, Majestic Products RHEDV Direct Vent Insert

	JR5	JR6
			JR4
JR2			JR3
		Burner Lava Rock	JR1
		Placement
LG279
Fig. 18	RHEDV25 log and lava rock placement.
	KR5	KR6
			KR4
KR2			KR3
			KR1

LG280	Burner Lava Rock
	Placement

Fig. 19	RHEDV32 log and lava rock placement.
	SR5	SR6
		SR4
SR2
		SR3
		SR1
		Front Lava Rock Placement
LG281
Fig. 20	RHEDV42 log and lava rock placement.

Large Lava Rock Placement

The large lava rock provided with this fireplace must be placed on the firebox base on either side of the burner assembly.

Under no circumstances should these lava rock be placed on top of the burner assembly.

Flame Adjustment (RN/RP Models)

For fireplaces equipped with HI/LO valves, flame adjustment is accomplished by rotating the HI/LO adjustment knob located near the center of the gas control. (Figs. 21 or 22)

Honeywell Valve

Turn
counterclockwise	LO	HI	Turn clockwise
to decrease			to increase
flame height			flame height

Fig. 21 Flame adjustment knob for Honeywell Valve.

	SIT Valve
Turn	IH	Turn clockwise
counterclockwise
		to decrease
to increase
		flame height
flame height	LO

Fig. 22 Flame adjustment knob for SIT Valve.

Temperature Adjustment (TN/TP Models)

The HI/LO reference on the control knob (Fig. 23) is to indicate a higher or lower temperature setting. This setting controls the heat by reducing then shutting off the flame as the desired temperature is reached. Position the control knob where it effectively maintains a comfortable room temperature.

Fig. 23 Temperature adjustment knob for TN/TP models.

Flame Characteristics

It is important to periodically perform a visual check of the pilot and the burner flames. Compare them to the Figure 24 and Figure 25 or 26. If any of the flames appear abnormal call a service person.

12 10000801