Vermont Casting RHEDV42, RHEDV25, RHEDV32 installation instructions Operating Instructions

Vermont Castings, Majestic Products RHEDV Direct Vent Insert

Operating Instructions

General Glass Information

Only ceramic glass approved by Vermont Castings, Majestic Products may be used for replacement on this unit.

1.The use of substitute glass will void all product warranties.

2.Care must be taken to avoid breakage of the glass.

3.Under no circumstances should this appliance be operated without glass properly installed, or with any cracked or broken glass. Replacement of any glass assembly as supplied by the manufacturer should be done by a licensed qualified service person.

Louvre Removal

Glass

Frame

10/24 Nut FP1286

Fig. 17 Remove four screws to remove glass frame.

To remove louvre pull louvre up and then lift out. (Fig. 16)

2.

1.

FP444

Louvre

Glass Panel

Log Installation and Burner Lava Rock

1 . Remove front glass. (See "Glass Removal" section)

2.	Remove logs from packaging.
3.	Place rear log (JR4, KR4 or SR4) on rear bracket
	(ensure log is seated properly, leveled and centered
	to the unit), so it will not move from side to side and
	is firmly positioned on the bracket.
4.	Slip front ember log (JR1, KR1 or SR1) down in the
	front deflector.

Fig. 16 Louvre removal.

Glass Cleaning

It will be necessary to clean the glass periodically. During start-up condensation, which is normal, forms on the inside of the glass and causes lint, dust and other airborne particles cling to the glass surface. Also initial paint curing may deposit a slight film on the glass. It is therefore recommended that the glass be cleaned two or three times with a non-ammonia household cleaner and warm water (we recommend gas fireplace glass cleaner). After that the glass should be cleaned two or three times during each heating season depending on the circumstances present.

Clean glass after first two weeks of operation.

5.	Place front left log (JR2 ,KR2 or SR2) on top
	burner, left side. Use log's bottom holes to locate it
	into the left bracket log locator studs.
6.	Place front right log (JR3, KR3 or SR3 ) on top of
	burner, right side. Use log's bottom holes to locate it
	into the right bracket log locator studs.
7.	Place burner lava rock material on top of burner.
	(Fig. 18, 19 & 20 for proper location).
8.	Place top right log (JR6, KR6 or SR6) onto locator
	notches. Ensure log is secure.
9.	Place top left log (JR5, KR5 or SR5) onto locator
	notches. Ensure log is secure.

Top logs must be placed properly into notches

Glass Frame Removal

1.Remove four (4) bottom fastening screws with a 3/8" nut driver. (Fig. 17)

2.Lift up and unhook glass frame at the top.

10000801 11