Vermont Castings, Majestic Products RHEDV Direct Vent Insert
Flue Collar Plate
FP1281
| Fastener |
| Plate |
Move | Cabinet |
Back | Top |
| 10/24" x 1¹⁄₂" |
| Machine Screw |
Flue Collar
Plate
FP1284
Fastener
Plate
Cabinet
Top
Make sure the flue collar plate is in contact with the back edge of the cabinet top
Fig. 10 Remove flue collar plate assembly.
Damper
3" Flex Vent
Two Pieces
Clamps &
Screw
Fastener
Plate
Gasket
Unit |
| FP1282 |
|
| |
Fig. 11 Apply high temperature sealant to end of collar. | ||
| Damper | 3" Chimney |
|
| |
|
| Liner Two |
Front |
| Pieces |
Frame |
| Clamps & |
|
| Screw |
|
| Flue Collar |
|
| Plate |
Unit | FP1283 |
Fig. 12 Fasten with two clamps, adjust fastener plate all the way back.
3.After the flue collar plate is set on the cabinet top, make sure the front edge of the flue collar plate is completely in contact with the back edge of the cabinet top. (Fig. 13)
4.Put the machine screw back into the fastener plate. Bolt the plate until it is locked. (Fig. 14)
NOTE: Insulation can be installed above the damper area only, provided the insulation material is of noncombustible type.
Under no circumstances should insulation be put between the damper and the top of the unit. This may cause condensation and overheating of the unit.
10000801
Fig. 13 The flue collar plate must be completely in contact with back edge of cabinet top.
Fastener Plate
Plate Flue
Collar
Cabinet
Top
FP1285 | Machine Screw |
After Fastened |
Fig. 14 Use machine screw to bolt fastener plate in place.
Ceramic Refractory Installation
1.Remove front glass.
2.Remove logs from unit.
3.Remove refractory from package
Refractory are fragile and must be han- dled with care. Where at all possible, two hands should be used when handling.
4.Take center refractory and tilt so bottom edge slides into support angle in back of fireplace. (Fig. 20)
5.Now press center refractory to back side of fireplace and hold in place.
6.Take left or right refractory and align it so leading edge faces outward. (Place refractory in fireplace side and slide it forward into side support angle on fireplace front. Leading edge of refractory must be completely behind side support angle of RHEDV32 for proper placement).
7.Now carefully slide in back side of refractory against fireplace side.
8.Repeat steps 6 and 7 for remaining side refractory.
When side refractory is installed cor- rectly, the center refractory will be sup- ported by the side refractory.
|
| Left Side | Center | Right Side | |||
| Leading |
| Leading | ||||
| Edge |
|
|
| |||
|
|
| Bottom |
|
| Edge | |
|
|
|
|
|
| ||
|
|
|
|
|
|
| |
|
|
|
| Edge | FP1287 | ||
|
|
|
|
| |||
| Fig. 15 Ceramic refractory. | 9 | |||||
|
|
|
|
|