Vermont Casting RHEDV42 A4 Riser Kits, B Trim Options for RHEDV32, Frame Assembly, Trim Assembly

Vermont Castings, Majestic Products RHEDV Direct Vent Insert

A4 Riser Kits

For use with RHEDV25 (Refer to Page 34, Figure 55)

1.Install the unit according to Homeowner’s Manual.

2.Install the trim according to Installation Instructions.

3.Remove the two (2) screws at the bottom of the trim.

4.Install the riser at the bottom of the trim. (Fig. 55)

5.Fasten the trim with the same two (2) screws removed on step 3.

Riser Trim Dimensions

	Length - A	Height - B	Depth - C
RHE25R1-Riser 1"	38.3" (973mm)	1" (25.6mm)	2.86" (72.8mm)
RHE25R-2Riser 2"	38.3" (973mm)	2" (50.9mm)	2.89" (73.6mm)
RHE25R5-Riser 5"	38.3" (973mm)	5" (127.9mm)	2.86" (72.8mm)

3.Install the trim top deflector and use two screws to fasten it. (Fig. 39 & 40)

4.Remove ALL plastic protective covering from brass trim.

	Trim Top
	Channel
Trim
Side		Trim
Channel		Side
	Deflector	Channel
Screw	Trim Top
		FP1260
Fig. 39	Install trim channels and trim top deflector.

B Trim Options for RHEDV32

B1 RHESS, RHESL, RHESSD, RHESLD, &

RHESXL Trims

For use with RHEDV32

Frame Assembly

RHESS, RHESL, RHESSD, RHESLD and RHESXL

1.Lay Trim Top Facing and Trim Side Facings, face down on to an even surface such as a table or floor. Be sure not to scratch the painted surfaces.

2.Install the nuts and bolts. (Fig. 38)

Rear View	10/24 Screws
	Frame Top

10/24

Nuts

Left

Frame

Right Frame

FP1259

Fig. 38 Attach left and right frame to frame top.

Trim Assembly

RHESS, RHESL and RHESXL (Fig. 39)

1.Install trim channels (left and right sides). Use two screws to assemble each piece.

2.Slide on the trim top channel and fasten it from the back side.

Side View

Trim Top Deflector

Trim Frame Top

Section

FP1261a

Fig. 40 Trim top deflector.

RHESSD and RHESLD (Fig. 41)

1.Install trim channels (left and right sides). Use two screws to assemble each piece.

2.Peel off plastic protective covering from top edges of the inner sides where they will be covered by the inner top trim facing.

3.Place the trim facing inner top in place (do not fasten it yet). Peel off the plastic protective covering from the bottom edge.

4.Install the trim top deflector and fasten it (will hold the inner top piece). Use two screws to assemble them.

5.Install trim channels (left and right sides). Use two screws to assemble each piece.

6.Slide on the trim top channel and fasten it from the back side.

7.Remove ALL plastic protective covering from brass trim.

26 10000801