Install the Optional Fan

If you are installing the optional convection Fan Kit #2767 (FK26), continue here. If you are not installing a Fan Kit, go to Page 14, Venting System Assembly.

1.The fan kit includes a Blower Assembly and a Rheo- stat Assembly, connected by a cable. (Fig. 12) The Blower Assembly mounts to the bottom rear of the stove, and the Rheostat mounts to the valve bracket to the left of the valve. The assembly includes a ‘snapstat’ which automatically turns the fan On (or Off) above (or below) approximately 109˚. The Rheo- stat also provides a range of fan speed settings from Off (which overrides the snapstat function) to High. Unpack and inspect the Blower assembly. Confirm the fan spins freely.

WARNING

This appliance is equipped with a three-prong (grounded) plug for your protection against shock hazard and should be plugged directly into a prop- erly grounded three-prong receptacle. Do not cut or remove the grounding prong from this plug.

Stardance Direct Vent/Natural Vent Gas Heater

4.The rheostat control switch attaches to the left side of the valve bracket at the front of the stove. (Fig. 15)

Remove retaining nut from shaft of rheostat. (if preinstalled)

Insert the rheostat through the hole in the back of the left side of the valve bracket, aligning the locator pin with the smaller hole in that bracket.

Thread the retaining nut onto the shaft of the rheostat, tightening with a wrench. Do not over- tighten.

Attach the control knob to the rheostat shaft.

Use the wire tie to secure the fan and rheostat wire harnesses together.

Rear Skirt

Sheet Metal

Screws

Not Used on RF Models

Not Used on

Stardance

Blower

Assembly

ST473

Snapstat Bracket

Snapstat/

Extension

Assembly

Rheostat

Assembly

Not Used on RF Models

Connect to PC Board on RF Models Only

 

Rear Skirt

ST313

 

Insert

 

Fig. 13 Remove rear skirt insert.

 

 

 

Star Washer

 

Sheet Metal Screws

 

 

1

2

Snapstat

Phillips

 

 

 

 

1/4” - 20

Pan Head

 

 

Hex Bolt

Bolts

 

 

 

 

 

Star

Washer

Snapstat

3 Bracket

Fig. 12 Fan kit components.

2.Remove the rear skirt insert panel at the bottom of the Rear Skirt (Fig. 13) and fasten the blower assem- bly to the firebox back with the two Phillips pan-head bolts originally installed in the firebox back. (‘1’, Fig. 14)

NOTE: Steps 3 and 4 do not apply when the RF valve is used. After attaching blower assembly to the firebox, run the spliced female leads to the front of the stove and attach to back of RF valve. (Page 28, Fig. 51)

3.Attach the snapstat assembly to the snapstat bracket with two sheet-metal screws. (‘2’, Fig. 15) Attach the snapstat bracket to the stove with a hex-head bolt passing through the bracket and into the stove base. (‘3’, Fig. 14)

NOTE: Shown

 

without shell for

ST314

clarification

Fig. 14 Attach the fan assembly and the snapstat.

Rheostat Retaining

Collar

Rheostat Knob

ST347a

 

Fig. 15 Attach the fan rheostat.

20007065

13

Page 13
Image 13
Vermont Casting SDV30 manual Install the Optional Fan, Remove rear skirt insert