Vermont Casting SDV30 manual Venting System Assembly - Natural Vent, General Information, 20007065

Stardance Direct Vent/Natural Vent Gas Heater

9.Install the storm collar and seal around the joints. (Fig. 31)

10.Add additional vent lengths to achieve the proper overall height.

11.Apply cement to the inner and outer termination col- lars and install the terminal cap.

#7DVAIS Attic Insulation Shield

Use Four	#7DVFS
8dNails	Firestop in
	Upper Floor

	#7DVFS
ST222	Firestop in
	Ceiling

Fig. 30 Install firestops and attic insulation shield.

Use three #5 sheet
metal screws at
each joint
	Sealant
Storm Collar
	Upper
	edge of
	flange
	goes under
	upper
	shingles
Flashing
#7DVSKV
(A, B, or F)
RoofSupport	ST221
Fig. 31 Roof support and flashing.

Venting System Assembly - Natural Vent

General Information

The Stardance Heater is shipped from the factory as a Direct Vent Heater. It may be converted to a Natural Vent heater by installing the Vermont Castings Model Z31D00 FSDHAG Draft Hood Adapter.

The Stardance Heater is approved for installation as a Natural Vent. CFM Direct Vent pipe could be used directly after the Draft Hood Adapter up to the ceiling, then B-vent pipe must be used. Do not mix types of B-vent pipe; use components from one maker or the other. Follow the vent component maker’s instructions exactly. The heater will also accept standard or enam- elled 7” (178mm) diameter pipe, around the Type B venting, for decorative purposes only. (Fig. 32)

NOTE: The restrictor plate supplied with the stove is not used for Natural Vent applications.

Decorative	CFM Direct Vent
	System may be
7” Pipe
	used after Draft
	Hood up to the
4” B-vent	ceiling
Pipe
Draft Hood
Adapter

ST358

Fig. 32 Decorative 7” pipe may be fitted around the B-vent pipe.

The Stardance stove, when installed as a Natural vent heater, includes a vent safety switch. (Page 36, Figure

66)Operating the stove when it is not connected to a properly installed and maintained venting system, or tampering with or disconnecting the vent safety switch, can result in carbon monoxide (CO) poisoning and pos- sible death.

For U.S. installations: The venting system must con- form with local codes and/or the current National Fuel Gas Code, ANSI Z22.1.

For Canadian installations: The venting system must conform to the current CSA B149.1 installation code.

18 20007065