8.The air shutter is located on the bottom of the burner to the left. Unfasten the two nuts holding the shutter in place. The shutter may be adjusted between the factory adjusted 1/2” to fully open. Reassemble the shutter to allow the rear injector air inlet to close from the minimum 1/2” opening to fully open. (Fig. 39) You may have to try more than once to find the correct air shutter opening for best results depending on your altitude.
Refer to | Air Shutter | |
(Original Position) | ||
Table 1 | ||
Burner | ||
|
ST352
Fig. 38 Air shutter in original
Front Injector | Air Shutter |
Air Inlet | (May be adjusted up to fully open) |
| Burner |
Rear Injector Air Inlet
ST351
Fig. 39 Air shutter adjusted.
9.Refasten the two nuts and assemble the burner into the unit by sliding the burner in at an angle with the left side lower than the right side. Slide the left side onto the injectors. Lower the right hand side down into place. Make sure the burner is as far left as pos- sible and the injector shoulders are inside the burner. NOTE: It is very critical to keep the left burner leg, which holds the injectors, at a 90° angle to the base. (Fig. 40) This keeps the orifices aligned with tubes on the inside of the burner. Failure to do so could affect the flame appearance and performance of the unit.
10.Refasten the right and left log bracket assembly.
11.Refasten the rear log bracket. 12.Replace logs.
13.Replace glass and stove front.
Follow lighting instructions on Page 25. Check flame color appearance. NOTE: Allow stove to burn for at least 1/2 hour to establish full flame color.
Should color need further adjustment, repeat steps 1 - 12 for air shutter adjustment.
Stardance Direct Vent/Natural Vent Gas Heater
Left Burner Leg |
Injector Shoulder |
90° |
ST353
Fig. 40 Be sure to maintain 90° angle at left burner leg.
Complete the Assembly
•Open the swiveling latches (cams) on the top left and right corners of the glass frame.
•Position the glass and frame against the firebox by placing the bottom edge on the brackets on the bot- tom face of the firebox.
•Swing the assembly against the firebox, and close the latches firmly against the pins protruding from the firebox top.
Install ON/OFF Switch
The switch assembly parts are found in the parts bag.
1.Attach switch assembly to left rear side of stove shroud (when facing shroud) using two screws and existing holes in shroud. (Fig. 41)
2.Run wires down back of stove, under bottom of rear shroud to valve.
3.Attach wires to valve terminals. (Fig. 42)
Switch | Existing Holes |
Assembly | |
Screws | ST315 |
| |
Fig. 41 Attach switch assembly to rear shroud. | |
PILOT ADJ |
|
TPTH |
|
TP |
|
TH | ST228 |
Fig. 42 Attach switch wires to valve.
20007065 | 21 |
