3-Wire Conduit Installation (See Figure 3.5)
1.Remove the Terminal Block Access Plate on the back of the range by unscrewing the 4 fixing Screws (Figure 3.4).
2.Check the correct positioning of the Conduit Bracket as per figure 3.5.
3.Feed 1/2” (1.3 cm) trade size Conduit through the hole in the
Conduit Bracket and secure to the Conduit Bracket with a Conduit Clamp.
4.Plug the terminal holes of conductors.
The Neutral or Ground Wire must be connected to the neutral terminal located in the center of Terminal Block.
The Power Wires must be connected to the outside terminals.
5.Plug washers and tighten nuts securely.
Do not remove Ground strap.
6.Reassemble the Terminal Block Access Plate on the back of the range by screwing the 4 fixing Screws (Figure 3.4).
1.Remove the Terminal Block Access Plate on the back of the range by unscrewing the 4 fixing Screws (Figure 3.4).
2.Check the correct positioning of the Conduit Bracket as per figure 3.6.
3.Feed 1/2” (1.3 cm) trade size Conduit through the hole in the
Conduit Bracket and secure to the Conduit Bracket with a Conduit Clamp.
4.Remove the 3 wire terminal nuts and washers from the Termi- nal Block.
5.Remove the Ground Strap from the frame of range and termi- nal by removing its screw and cutting it as shown in Figure 3.6.
6.Plug the terminal holes of conductors.
The Neutral Wire must be connected to the neutral terminal located in the center of Terminal Block; the Power Wires must be connected to the outside terminals; the Ground Wire must be attached to the frame of range by using the (Ground) identi-
fied 
Grounding Screw.
3 |
Fig. 3.4 |
Screws |
Screws |
Terminal Block |
Access Plate |
Fig. 3.5 |
|
|
| Ground strap | |
| Neutral Wire | Terminal Block |
A | Power Cord |
|
Bracket |
| |
|
| |
| B |
|
A: D=1” 9/64 (29 mm) |
| |
B: D=7/8” (22.5 mm) |
| |
| Conduit Clamp | Power Wires |
| Conduit | |
|
| |
Fig. 3.6
Cut Ground Strap
7.Plug washers and tighten nuts securely.
8.Reassemble the Terminal Block Access Plate on the back of the range by screwing the 4 fixing Screws (Figure 3.4).
Neutral Wire
APower Cord
Bracket
B
A: D=1” 9/64 (29 mm)
B: D=7/8” (22.5 mm)
Terminal Block
Grounding |
Screw |
Power Wires |
| Grounding Wire | |
| |||
| |||
| Conduit | ||
Conduit Clamp |
| ||
| |||
|
| 21 | |
|
| ||
|
|
| |
|
|
| |
