Vertex Standard VX-8R ELL, PTT, PTT, T-D, SQL, D-T, DIAL, DIAL, D CD, VX-8R, SPLIT, SELECT, INSERT, 94: SQL, MESSAGE, CD-TONE, PERATION, TONE-DCS, 95: SQL TYPE

CTCSS/DCS/EPCS OPERATION

CTCSS/DCS/EPCS BELL OPERATION

12. When you wish to add a beep tone into the beep melody

strings, move the cursor to the place where you wish to en-

ter the beep tone using the / key, then press the

key repeatedly until the “SELECT” notation in the “Op-

eration Mode” slot turns into “INSERT”. Now, press and hold in the key for one second to add the new beep tone (Tone: “C2”, Tone Length: “500mS”).

13.Press and hold the key for one second to delete all data after the current position that may have previously been stored in the User Beep Melody.

14.When you have programmed User Beep Melody, press the PTT switch briefly to save the new setting and exit to normal operation.

You may check your work by monitoring the programmed User Beep Melody.To do this, repeat steps 1 - 4 above, then press the key.SPLIT TONE OPERATION

The VX-8Rcan be operated in a Split Tone configuration via the Set mode.

1.Press and hold the key for one second to enter the Set Mode.

2.Rotate the DIAL knob to select Set Mode Item 94: SQL

SPLIT.

3.Press the key briefly to enable adjustment of this Set

Mode Item.

4.Rotate the DIAL knob to select “ON” (to enable the Split Tone feature).

5.Press the PTT switch briefly to save the new setting and

exit to normal operation.

When the Split Tone feature is activated, you can see the following additional parameters after the “MESSAGE” parameter while selecting the Set Mode Item 95: SQL TYPE:

D CD: DCS Encode only (“DC” icon will appear while operating)

TONE-DCS: Encodes a CTCSS Tone and Decodes a DCS code (the “T-D” icon will appear during operation)

D CD-TONE SQL: Encodes a DCS code and Decodes a CTCSS Tone (the “D-T” icon will appear during operation)

Select the desired operating mode from the selections shown above.

44 VX-8R OPERATING MANUAL