Vidikron 85 manual Installing and Adjusting the CineWide Anamorphic Lens

Installation

3.10

Installing and Adjusting the CineWide Anamorphic Lens

Anamorphic Lens Installation ➤

and Adjustment - Vision

85/CineWide

If you are installing a CineWide-equipped projector, proceed as follows to install and adjust the anamorphic lens.

It is extremely important that the primary lens is properly adjusted

Note before you install the anamorphic lens. Ensure that the image from

the primary lens is perfectly centered on the screen.

The standard Vision 85/CineWide uses a prismatic-style anamorphic lens. This type of lens compresses the height of the image (as opposed to stretching the width) to achieve a 2.35:1 aspect ratio with a 1.78:1 display device.

The Vision 85/CineWide with AutoScope uses a cylindrical anamorphic lens with a much larger aperture than the prismatic lens used with the standard Vision 85/CineWide.

If you are installing a Vision 85/CineWide with AutoScope, refer to Anamorphic Lens Installation and Adjustment - Vision 85/CineWide with AutoScope on page 41. If you are installing a standard Vision 85/CineWide, continue with the next section.

The standard Vision 85 Anamorphic lens mount kit consists of everything shown in Figure

3-20.Some components shipped with your projector may differ slightly from what is shown in these instructions.

If any items are missing or damaged, please contact your Vidikron dealer or Vidikron Customer Service at (888) 4VIDIKRON.

1Anamorphic Lens

2 Base Plate

3Screw, Phillips

10-32 x 1/2" (4x) and Washer (4x)

(not shown; secures Base Plate to bottom of projector)

6Pitch/Y-Adjustment Screw, Phillips

Pan Head, 4-40 x 5/16" (4x) and Fender Washer (4x)

5Vertical Mounting

Bracket (2x)

4Yaw/Z-Adjustment Knob (2x) and Washer (2x)

Figure 3-20. Vision 85 Anamorphic Lens Mounting Assembly - Exploded View

1.Use the Pitch Adjustment Screws and Washers (item #6) to attach the Vertical Mounting Brackets (item #5) to the Anamorphic Lens (item #1).

2.Place the lens with the brackets installed on top of (or under, if the projector is inverted) the Base Plate (item #2), so that the two threaded posts at the bottom of the brackets pass through the corresponding slots on the base plate.

38 Vidikron Vision 85 Owner’s Operating Manual