By default, the Vision 85 is configured for a “floor/front” installation, in which the projector is installed upright and in front of the screen. If it is installed behind the screen and/or mounted on a ceiling, you must change the picture orientation. To do this:
1.Select an input OTHER THAN HDMI 1 or HDMI 2 on the VHD Controller.
2.Press MENU and enter the Service Menu passcode.
3.Select Service from the Main Menu.
4.Select Display Device from the Service Menu, then select Configure.
5.Press 
, then choose Floor/Rear, Ceiling/Front or Ceiling/Rear, to match the installation method.
You must enter a passcode to access the Service menu.
Note
3.8
Adjusting the Picture Orientation
To focus the projected image, gently rotate the lens by hand.
To enlarge the picture (zoom in), move the zoom tab toward the Vidikron logo on the front of the projector. To make the picture smaller (zoom out), move the tab in the other direction.
3.9
Primary Lens Adjustments
Zoom | Focus and Zoom |
in |
|
Zoom out
Focus
To change the projected image position, use a 9/64” hex driver to shift the lens in the desired | Vertical Lens Shift | ||
direction; see Figure |
| ||
tool will automatically center on top of the adjustment nut when inserted into the access |
| ||
hole.) |
| ||
|
| 9/64” Hex Wrench |
|
|
|
| |
Figure 3-19. Vertical Lens Shift Adjustments
Vidikron Vision 85 Owner’s Operating Manual | 37 |
