Maintenance
Internal clock battery
Consumption of the battery makes the clock not to work correctly. When the clock is wrong or it has stopped, please replace the battery according to the following procedures.
1.
2.
3. Remove the battery cover.
Turn the battery cover in the direction indicated “OPEN” using such as coins. Then the battery cover will come up. While removing the battery cover, pick its knob.
4. Take the old battery out.
Press the metal claw of the battery holder. Then the battery will come up. Remove the battery.
Battery Cover
OPEN
5. Replace battery with HITACHI MAXELL, Part No.CR2032 only.
Use of another battery may present a risk of fire or explosion. Insert a new battery in the battery holder according to its minus terminal – as indicated in the battery holder, so that the side marked by + is facing. And push the battery into
6. the battery holder fully to fix. Close the battery cover.
Replace the battery cover in place, then turn it in the direction
WARNING | indicated “CLOSE” using such as coins, to fix. |
►Always handle the batteries with care and use them only as directed. Battery |
may explode if mistreated. Do not recharge, disassemble or dispose of in fire.
And also improper use may result in cracking or leakage, which could result in fire, injury and/or pollution of the surrounding environment.
•Be sure to use only the batteries specified.
•Make sure the plus and minus terminals are correctly aligned when loading a battery. If the battery is placed in the battery holder
•Keep a battery away from children and pets. If swallowed consult a physician immediately for emergency treatment.
•Do not short circuit or solder a battery.
•Do not allow a battery in a fire or water. Keep batteries in a dark, cool and dry place.
•If you observe battery leakage, wipe out the leakage and then replace a battery. If the leakage adheres to your body or clothes, rinse well with water immediately.
•Obey the local laws on disposing the battery.
NOTE • If the battery is placed in the battery holder
1.Remove the battery cover as described in steps 1 through 3 above.
2.Turn the projector over again, so that the top of the projector is facing up.
3.While lifting the side of the projector closest to the lens, press the metal claw of the battery holder. The battery will fall out of the holder, so be careful not to lose it.
4.Turn the projector over once more, so that the bottom faces up, and reload the battery correctly.
• The internal clock’s time will be reset when the battery is removed.
Please reconfigure the time via the menu or a web browser after replacing the battery.
ViewSonic | 107 | PJ1173 |
