Viking F21233A Replacing Oven Lights, To start the Self-Clean cycle, To stop the Self-Clean cycle

Self-Clean Cycle (VDR Dual Fuel models)

To start the Self-Clean cycle:

1. Close the door completely.

2. Turn the oven selector knob clockwise to the “SELF CLEAN” mode.

3. Turn the temperature control knob to the clean setting stop. At this

time, the clean indicator light will come on. Within 30 seconds the

automatic door latch engages and the oven indicator light comes

on. The oven indicator light will remain on until the oven reaches the

self-clean temperature and will then cycle on and off during the self-

clean cycle. When the oven reaches the elevated temperature

needed for self-clean, the door lock indicator light comes on.

4. The door lock indicator light will remain on until the self-clean is

completed or interrupted and the oven temperature drops to a safe

temperature. A complete cycle is approximately 2-1/2 hours with an

additional 30 minutes needed for the oven to cool down enough for

Replacing Oven Lights

WARNING

ELECTRICAL SHOCK HAZARD

Disconnect the electric power at the main fuse or circuit breaker before replacing bulb.

WARNING

DO NOT touch bulb with bare hands. Clean off any signs of oil from the bulb and handle with a soft cloth.

DO NOT touch bulb with bare hands. Clean off any signs of oil from the bulb and handle with a soft cloth.

the door latch to disengage.

Note: A fan noise will be heard during the self-clean cycle and will

continue to run for the 2-1/2 hour duration of the self-clean cycle.

Note: On griddle model ranges, the griddle/simmer plate will not

function during the self-clean cycle.

1.Unsnap glass light cover using a screwdriver in the access groove.

2.Firmly grasp light bulb and pull out.

1

1

5. When the cycle is completed, turn both the oven selector and

temperature control knob to the “OFF” position. When the oven has

completely cooled, open door and remove any ash from the oven

surfaces with a damp cloth.

To stop the Self-Clean cycle:

To cancel or interrupt the self-cleaning cycle, turn both the temperature control knob and the oven function selector knob to “OFF”. When the oven temperature drops to a safe temperature, the automatic door latch will release and the oven door can be opened. When the oven has completely cooled, remove any ash from the oven surfaces with a damp sponge or cloth.

Product Care

54

3.	Replace with halogen bulb
	using volt and wattage	2
	requirements listed on glass
	cover.
4.	Replace the light cover by	3
	snapping glass cover onto
	metal box.	4
5.	Reconnect power at the main
	fuse or circuit breaker.

Product Care

55