LIMITS SETUP
!NOTE:
1.The 1st cycle after the limit setup is the “Learn Cycle”. Allow a complete cycle to confirm your settings.
2.During the limit setup process, the operator will run at half speed.
Limit
Open
To Readjust the Open Limit:
1.Clear the current limit setting by holding down the “Open Limit” button until the LED is flashing.
2.Repeat STEP 2 on page 20 to set the
limit.
Limit
Close
To Readjust the Close Limit:
1.Clear the current limit setting by holding down the “Close Limit” button until the LED is flashing.
2.Repeat STEP 3 on page 20 to set the limit.
VIKING TECHNICAL SUPPORT 1.800.908.0884 | 2 1 |
|
|
