| TROUBLESHOOTING |
LCD Display References |
|
LCD MSG Meaning | Page 41 |
TS Ref #s |
Multi Meter Displays
MOT AMP __._ A
MOT VOLT __._ VDC
AC VOLT __._ VAC
CHARGE __._ VDC
BAT VOLT __._ VDC
This is the motor current amperage during operation
This is the actual motor voltage during operation
This is the actual low voltage AC to the Control Board from the transformer
Indicates the charging voltage to the batteries, if the Battery Switch is in the OFF position.
Indicates battery voltage, if the AC power is discontinued to the Control Board.
EPS2
___% ERR
SPEED __%
OVERLAP _._ SEC
ODS SENS
___%
TIMER __ SEC
HEATER __ OFF
HEATER __ ON
LOCK MOD OFF
LOCK MOD ON
Board Settings Messages
Indicates that the Electronic Positioning Sensor (EPS) needs to be tuned. Error rate is displayed as a percentage
Shows the percentage of speed set by the Speed adjustment on the control board. (pg. 24)
Shows the number of seconds set by the Overlap Adjustment on the con- trol board. This feature is not available on slide gate operator models
Shows the force setting selected to trip the obstruction sensor. (pg. 26)
Shows the amount time set or remaining to hold the gate at the Open Limit position, before the gate starts to close. (pg. 24)
The Integrated Heater is disabled for the open “OPN” and/or close “CLS” limits (pg. 27)
The Integrated Heater has been enabled to turn on at the open “OPN” and/ or close “CLS” limits (pg. 27) “*” will be displayed while it is heating
The Lock Mode feature is turned OFF (pg. 27)
The Lock Mode feature is turned ON (pg. 27)
VIKING TECHNICAL SUPPORT 1.800.908.0884 | 3 9 |
|
|
