Initial Settings | Viking Access Systems H-10 instruction

CONTROL BOARD SETUP

Initial Settings

“Timer”

Hold Open Timer

Automatically closes the gate after the selected amount of time from 1-60 seconds.

Turning the dial between “0” and “OFF” will disable this feature, requiring a close command to close the gate.

“ODS”

Obstruction Detection Sensor

Sets the amount of force required to trip the inherent obstruction sensor.

See page 26 for more details about this feature.

“Overlap” Overlap Delay

Delays the gate from opening for the selected amount of time from 1-6 seconds.

!Typically not used on slide gates. For Master/Slave application, the control board that has this feature turned on is the master and will close first.

“Speed” Motor Speed

Increases or decreases the speed of gate travel.

2 4	VIKING TECHNICAL SUPPORT 1.800.908.0884

Image 26

Viking Access Systems H-10 manual Initial Settings, Timer Hold Open Timer, Obstruction Detection Sensor

Contents

Instructions Viking H-10 Slide Gate Operator Vehicular Gate Operator Revision H10NXMN10.E December Parts Diagram Description Operator References EMI Board Connector Control Board References Table of Contents Important Safety Information Important Safety Instructions Important Installation Instructions Maintenance UL325 Gate Operator Classifications Glossary Photo Beam non-contact sensor Installation Secondary Entrapment Protection Manual Release Edge Sensor contact sensor InstallationWhen manual operation is required Audible Alarm Reset Switch Installation Manual Reset for the Audible Alarm Alternative Power 24VAC / VDC 60VA or Solar SpecificationsSingle Phase 50 Hz / 60 Hz Locate Control Buttons Gate Operator Installation Concrete Pad Option Post Mounting Option Operator Positioning Step High Voltage Supply Option Electrical InstallationTips for proper ground installation Low Voltage Supply Option Solar Supply Option Limits Setup 1a 1b To Readjust the Open Limit To Readjust the Close Limit MS1 MS2 MASTER/SLAVE SetupTwo Wire Communication Wireless Communication Options Required ADD-ON Choose option a or B Obstruction Detection Sensor Initial SettingsTimer Hold Open Timer Last Open Power Failure Option Control Board SetupAuto Open Power Failure Option Fail Safe/Secure Obstruction Sensor Primary Entrapment Protection ODS Obstruction Detection Sensor Viking Lock Mode Viking Heater This page Left Blank Intentionally COM + Accessory ConnectionsRe-Open Photo Beam vehicular Safety Check for proper operation Open Only Radio Receiver TypicalOpen-Stop-Close Guard Station Anti-Tailgate, Open Commands & Guard StationOpen Commands ATG Anti-Tailgate Viking Loop Rack Accessory Connections Guidelines for Loop Installation Magnetic Lock Lock Solenoid Power for the LocksMagnetic Lock, Lock Solenoid Synchronization with B-12 Barrier Arm B-12 Synchronization Option Troubleshooting LED References Troubleshooting LCD MSG Meaning LCD Display References Troubleshooting Error Messages Solutions Check Access Control Connections Power Connections General Appendix aRelays In General Technical TIP Viking uses Common Radio Receivers Connections Panels Appendix CSolar Applications Batteries & Fuse Viking Konnect Master/Slave Kit Secure and reliable Viking Konnect Diagnostic Tool On-site remoteViking Expansion Products OUR Continuous Commitment to Excellence Standard Features