Manuals / Viking Access Systems / Photography / Photo Scanner

Viking Access Systems H-10 Locate Control Buttons, Specifications, Single Phase 50 Hz / 60 Hz

Models: H-10

1 50

Download 50 pages 39.49 Kb

Page 15

IMPORTANT INSTALLATION INFORMATION

!CAUTION: To Reduce the Risk of Fire or Injury to Persons:

!WARNING: For use with gates at a maximum 2200 lbs. in weight or 75 ft. in length.

DO NOT allow pedestrian use of this gate

DO NOT install the gate operator to lift gates

Locate Control Buttons:

1.Within sight of the gate,

2.At a minimum height of 5 feet so small children are not able to reach it; and

3.At least 6 feet away from all moving parts of the gate.

2200 lb.

75 ft

Specifications:
Maximum Gate Length:	75 ft.
Maximum Gate Weight:	2200 lb.
Operating Temperature:	-20°F (-28°C) to 160°F (71°C)
Power Requirements:	115VAC / 230 VAC (6.0* Amp / 1.0 Amp) *Includes 3 amp load on receptacle
	Single Phase (50 Hz / 60 Hz)
Alternative Power	24VAC / VDC (60VA) or Solar

VIKING TECHNICAL SUPPORT 1.800.908.0884	1 3

Image 15

Viking Access Systems H-10 manual Locate Control Buttons, Specifications, Single Phase 50 Hz / 60 Hz

Contents

Instructions Viking H-10 Slide Gate Operator Vehicular Gate Operator Revision H10NXMN10.E December Description Parts DiagramOperator References Control Board References EMI Board ConnectorTable of Contents Important Safety Instructions Important Safety InformationImportant Installation Instructions Maintenance Glossary UL325 Gate Operator ClassificationsSecondary Entrapment Protection Photo Beam non-contact sensor InstallationEdge Sensor contact sensor Installation When manual operation is requiredManual Release Manual Reset for the Audible Alarm Audible Alarm Reset Switch InstallationLocate Control Buttons SpecificationsSingle Phase 50 Hz / 60 Hz Alternative Power 24VAC / VDC 60VA or SolarConcrete Pad Option Gate Operator InstallationPost Mounting Option Operator Positioning Step Electrical Installation Tips for proper ground installationHigh Voltage Supply Option Solar Supply Option Low Voltage Supply Option1a 1b Limits SetupTo Readjust the Close Limit To Readjust the Open LimitMASTER/SLAVE Setup Two Wire CommunicationMS1 MS2 Required ADD-ON Choose option a or B Wireless Communication OptionsInitial Settings Timer Hold Open TimerObstruction Detection Sensor Fail Safe/Secure Control Board SetupAuto Open Power Failure Option Last Open Power Failure OptionODS Obstruction Detection Sensor Obstruction Sensor Primary Entrapment ProtectionViking Heater Viking Lock ModeThis page Left Blank Intentionally Check for proper operation Accessory ConnectionsRe-Open Photo Beam vehicular Safety COM +Radio Receiver Typical Open-Stop-CloseOpen Only ATG Anti-Tailgate Anti-Tailgate, Open Commands & Guard StationOpen Commands Guard StationViking Loop Rack Guidelines for Loop Installation Accessory ConnectionsPower for the Locks Magnetic Lock, Lock SolenoidMagnetic Lock Lock Solenoid Barrier Arm B-12 Synchronization Option Synchronization with B-12LED References TroubleshootingTroubleshooting LCD Display References LCD MSG MeaningTroubleshooting Error Messages Check SolutionsPower Connections Access Control ConnectionsTechnical TIP Viking uses Appendix aRelays In General GeneralCommon Radio Receivers Connections Batteries & Fuse Appendix CSolar Applications PanelsViking Konnect Diagnostic Tool On-site remote Viking Expansion ProductsViking Konnect Master/Slave Kit Secure and reliable OUR Continuous Commitment to Excellence Standard Features