Watching TV
06
Unless you set up TV channels that you can watch under the current conditions, you cannot tune in those channels. For the procedure, see “Setting up TV channels automatically” on page 27.
Turning on/ off the power
NOTE
•When the Media Receiver is plugged into a power outlet, it is placed into the standby mode; the STANDBY indicator on its front panel should flash red. The Media Receiver stays in the standby mode unless it is unplugged from the power outlet.
To turn on the system, press POWER on the Plasma Display.
•The POWER ON indicators on the Plasma Display and Media Receiver light up in blue.
To turn off the system, press aon the remote control unit or STANDBY/ON on the Media Receiver.
•The Plasma Display and Media Receiver are placed into the standby mode; their respective STANDBY indicators light up in red.
•You can then turn on the system again by pressing aor 0 to 9 on the remote control unit or STANDBY/ON on the Media Receiver. If you press 0 on the remote control unit, images come from the INPUT 1 source. If you press 1 to 9, TV images display.
You can also press POWER on the Plasma Display to turn off the system. However, you cannot then turn on the system again by pressing the buttons on the remote control unit and Media Receiver.
NOTE
•If you are not going to use the Plasma Display System for a long period of time, be sure to remove the power cord from the power outlet.
•When the system is placed into the standby mode, the main power flow is cut and the system is no longer fully operational. A minute flow of power feeds the system to maintain operation readiness.
Plasma Display/Media Receiver status indicators
The table below shows the operational status of the Plasma Display System. You can check the current status of the system with the indicators on the Plasma Display and Media Receiver.
Plasma Display
STANDBY indicator
POWER ON indicator
POWER button
Media Receiver
ONSTANDBY
PULL |
OPEN |
STANDBY/ON |
STANDBY indicator |
POWER ON indicator |
STANDBY/ON |
English
| Indicator Status |
| System Status | |
Plasma Display | Media Receiver | |||
|
|
|
|
|
POWER ON | STANDBY | POWER ON | STANDBY | |
|
|
|
|
|
|
|
|
| The power cords of both the Plasma Display and the Media Receiver have been |
|
|
|
| disconnected. Or, the power cord of the Plasma Display has been connected but |
|
|
|
| the POWER button of the Plasma Display is off. |
Power to the system is on.
The system is in the standby mode.
The power cord of the Media Receiver has been disconnected.
Flashing
Power to the Plasma Display is off. Or the power cord of the Plasma Display has
been disconnected.
Flashing
For other than the above, see “Troubleshooting” on page 46.
21
En
