05Preparation

Routing cables

Speed clamps and bead bands are supplied for bunching cables. Once properly bunched, follow the steps below to route the cables.

When the speakers are installed on the sides

(rear view)

Speaker cable

Speed clamp

Speed clamp

 

 

Speaker cable

Cable binder (supplied with the stand)*

Attaching speed clamps to the main unit

Attach the speed clamps using the 2 holes marked with below, depending on your routing system.

Attaching and removing speed clamps

Insert [1] into an appropriate hole on the rear of the Plasma Display and snap [2] into the back of [1] to lock the clamp.

Speed clamps are designed to be difficult to undo once in place. Please attach them carefully.

Use pliers to twist the clamp 90°, pulling outward. The clamp may deteriorate over time and become damaged if removed.

2

1

When the speakers are installed at the bottom (PDP-436FDE only)

Speaker cable

NOTE

• Use the supplied bead bands as necessary.

Cable binders (supplied Speaker cable with the stand)*

*Cable binder

Using the cable binders supplied with the stand, put the speaker and system cables together so that the cables are invisible from the front. At that time be careful not to apply any force to the connection sections of the cables.

18

En

Page 18
Image 18
Pioneer PDP-506FDE, PDP-436FDE operating instructions Routing cables, When the speakers are installed on the sides Rear view