SUPER MICRO Computer 6026TT-GIBQRF, 6026TT-GTRF, 6026TT-GIBXRF Dimm Installation Notch, Front View

SUPERSERVER 6026TT-GTRF/GIBXRF/GIBQRF User's Manual

DIMM Population Table

DIMM	DIMMs	DIMM Type (Reg.=	Speeds (in MHz)	Ranks per DIMM
Slots per	Populated	Registered)		(any combination;
Channel	per Channel			SR=Single Rank,
				DR=Dual Rank,
				QR=Quad Rank)
2	1	Reg. DDR3 ECC	800,1066,1333	SR or DR
2	1	Reg. DDR3 ECC	800,1066	QR
2	2	Reg. DDR3 ECC	800,1066	Mixing SR, DR
2	2	Reg. DDR3 ECC	800	Mixing SR, DR,QR

To Install: Insert module vertically and press down until it snaps into place. Pay attention to the alignment notch at the bottom.

To Remove:

Use your thumbs to gently push the release tabs near both ends of the module. This should release it from the slot.

Figure 5-2. DIMM Installation
Notch	Notch

Front View

Note: Notch should align with
the receptive key point on
the slot.	Release Tab
Release Tab

Top View of DDR3 Slot

Due to the memory allocation to system devices, the amount of memory that remains available for operational use will be reduced when 4 GB of RAM is used. The reduction in memory availability is disproportional. Refer to the table below.

5-8