SUPER MICRO Computer 6026TT-GIBXRF Serial ATA Ports, BMC Activity LED LE2, Rear UID LED LE4

Chapter 5: Advanced Serverboard Setup

BMC Activity LED (LE2)

A BMC Heartbeat LED is located at LE2 on the serverboard. When LE2 is on, BMC (Baseboard Management Controller) is active. See the table at right for more in- formation.

HDD/SATA LED (LE3)

An HDD/SATA LED is located at LE3 on the serverboard. This LED indicates the status of hard drive activitiy or SATA activity supported by the South Bridge.

Rear UID LED (LE4)

The Rear UID LED is located at LE4 on the serverboard. Refer to Section 5-7 for details.

5-10 Serial ATA Ports

Serial ATA Connections

A Front Panel Add-On Card header is located at JF2 on the serverboard. This header provide onboard SATA support. Plug an add-on card in JF2 to use SATA connections. These connections provide serial-link signal transmission, which is faster than that of the traditional Parallel ATA.

BMC Heartbeat LED

On BMC is normal

HDD/SATA LED

(LE3)

Status Definition

On	HDD/SATA
	Connected
Off	No connection

5-19