Chapter 5: Advanced Serverboard Setup

Serial Ports

One serial port is included on the serverboard.

Serial Port Pin Definitions

Pin Definitions

The COM port is located beside the VGA port. See the table on the right for pin defini- tions.

Pin # Definition

1DCD

2RXD

3TXD

4DTR

5Ground

Pin # Definition

6DSR

7RTS

8CTS

9RI

10NC

(NC: No Connection)

System Reset

If System Reset (JRST1) is connected to a switch, then the system reset feature is enabled. See the table on the right for pin definitions.

Unit Identifier Switches

Two Unit Identifier (UID) switches and LED indicators are located on the serverboard. The Front Panel UID Switch is located at pin 16 on JF2. The Rear UID Switch is located at SW1 next to the InfiniBand Connector. The Front Panel UID LED is located at pin 17 of JF2, and the Rear UID LED is located at LE4. When you press the UID switch on the front panel or on the back panel, both Rear UID LED and Front Panel UID LED indicators will be turned on. Press the UID switch again to

Alarm Reset

Pin Definitions

Pin#

 

Definition

Pin 1

 

3.3V

 

Pin 2

 

Ground

 

 

 

 

UID Switch

Pin Definitions

Pin# Definition

1Ground

2Ground

3Button In

4Ground

UID Switches & LEDs

turn off both LED Indicators. These UID Indi- cators provide easy identification of a system unit that may be in need of service. See the table on the right for pin definitions.

Note: UID LED is supported by the physical switch or the BMC. When it is controlled by the physical switch, it will stay solid. When it is controlled by the BMC, it will blink.

Description

FP Switch

Rear Switch

FP UID LED (Blue LED)

Rear UID LED

Location

Pin 16 on JF2

SW1

Pin 17 on JF2

LE4

5-15

Page 49
Image 49
SUPER MICRO Computer 6026TT-GTRF, 6026TT-GIBQRF, 6026TT-GIBXRF Serial Ports, System Reset, Unit Identifier Switches