S T E P 4 GREEN BAG
•Place the two rubber bumpers (Q05) over the holes for the guide rods in center floor support (AC1). With the horizontal holes at the bottom, slide the guide rods through the rubber bumpers and into center floor support. Let the guide rods tilt forward. Slide each of the 15 weight plates over both of the guide rods on top of one another. Place the header weight plate over both guide rods on top of other weight plates. Slide a travel limiter ring on the left guide rod, tightening the ring 10.5” (bottom edge of ring) from the top.
•Make sure rubber guide rod sleeves are in place in top holes of the center pulley support(AB1). Lift the guide rods up until holes in guide rods are lined up with holes in center floor support. Slide a bolt (M8x50) with a flat washer (8.4x15.5x1.6) through each guide rod, securing bolt with another flat washer and nylon nut (M8). Tighten all hardware (horizontal hardware first, then vertical hardware).
12
