S T E P 8 | CABLE #4 |
Remove the nut and slotted bolt from the end of cable #4. Starting at the right adjustment handle (AD2), route cable through pulleys S, T, U, V, W, through the front of X, around the back of pulley Y and over the back of pulley Z. Guide the cable through the inside of the hole on the side of the right top cap (Q04). Exit the hole and allow the cap to be sus- pended by the cable. Finish routing the cable over Pulley AA and down to the anchor. Reattach the slotted bolt and nut to the end of the cable. Thread it in a minimum of 0.5”. Tighten nut against anchor.
Q04
Z
AA
S
X
T
W
AD2
Y
V
U
16
