S T E P 7
Q03
Q
R
AD1
J
K
O
P
L 
M
N
CABLE #3
Remove slotted bolt and nut from the end of Cable #3. Cable #3 starts at the left adjustment handle (AD1). Guide the cable in between Pulleys J and K and down length of upright, around Pulleys L, M, N. Weave the cable up around the front of pulley O, through the back of pulley P, and over the back of pulley Q. Guide the cable through the inside of the hole on the side of the left top cap (Q03). Exit the hole and allow the cap to be suspended by the cable. Finish routing the cable over Pulley R and down to the anchor. Reattach the bolt and nut to the end of the cable and thread in a minimum 0.5”. Tighten nut against anchor.
15
