![](/images/new-backgrounds/1144898/14489833x1.webp)
N O T E : Before assembling shields, make sure all cable connection points are adjusted properly. The weight selector pin should be able to be inserted without obstruction. Check all three cable ends that accessories connect to. There shouldn’t be more than 0.75” of cable slack (cable travel prior to weight stack movement) at any of these locations. Tighten cable termination bolts to decrease slack or loosen to increase slack.
B26
Z19
S T E P 9 B L A C K B A G
•Slide the
•Attach the left and right top shields (Q03 & Q04) to the top center pulley support (AB1) using four bolts (M5x15). Attach the back of the top shields to the top rear frame using two bolts (M10x70), four flat washers (10.2x22x2) and two nylon nuts (M10).
AB2
AC1
17