VIVOTEK
Hardware Installation
1.Attach the alignment sticker to the wall. Drill four holes into the wall. Then hammer the supplied plastic anchors into the holes and secure the plate with supplied screws.
2.Fix the intersection bracket to the side of the Network Camera with two screws.
3.Feed the RJ45 cable through the front opening of the wall mount bracket. (If you want to use external devices such as sensors and alarms, please refer to the assembling steps on the next page.)
4.Open the lens cover.
5.Push the spring mortise and hook the bracket onto the groove of the wall mount bracket.
6.Secure the two screws on the other side of the wall mount bracket.
7.Hang the wall mount bracket on the plate.
8.Fix the wall mount bracket with the supplied screws.
9.Adjust the angle of the wall mount bracket to aim at the area of interest.
1
2
4
3
6
5
7
9
8
10 - User's Manual
