Vivotek IP8361 Components of the Waterproof Connector, Pin Definition, Assembling Steps

VIVOTEK

Waterproof Connector

Components of the Waterproof Connector Pin Definition

Screw Nut (A)

Seal (B)

Seals (C)

Housing (D)

Sealing Nut (E)

1	2	3	4	5	6	7	8
	4	3	2	1

1Power +12V

2Digital Output

3Digital Input

4Ground

5AC 24V

6AC 24V

7RS485 +

8RS485 -

Assembling Steps

1External MIC In

2Ground

3Audio Out

4Ground

1.Disassemble the components of the waterproof connector into part (A) ~ (E) as shown above.

2.Open the back cover of the Network Camera.

3.Remove the rubber stopper from the bottom of the Network Camera and secure the screw nut

(A)tightly.

4.If you need extra power for external devices, please feed the power cable through the wall mount bracket and the waterproof connector (E --> D --> B --> A) as the illustration shown below. Then connect the power cord to the socket. Note: There are 7 holes on the seal (B), and the widest hole with a crack on the side is specific for power cord.

5.If you have external devices such as sensors and alarms, feed the cables through the wall mount bracket and the waterproof connector (E --> D --> B --> A) as the illustration shown below. Then refer to the pin definition to connect them to the general I/O terminal block. Note:

The recommended cable gauge is 2.0 ~ 2.8 mm.

6.Push the seal (B) into the housing (D).

7.Insert the seals (C) into the empty holes on the seal (B) to avoid moisture.

8.Secure the sealing nut (E) tightly.

5

3 (A)

(B)

(D)

(E)

4

7

(B) (C) 6 (D)

4

8

(E)

User's Manual - 11