Vulcan-Hart GCO2D ML-114569 Before First Use, USING THE GCO2C OVEN Preheating, Cooking

BEFORE FIRST USE

Before using the oven for the first time, it must be "burned in" to release any odors that might result from heating the new surfaces in the chamber.

1.Using a clean damp cloth, wipe the inside of the oven, including the racks.

2.Close the oven door, push the ON / OFF / OVEN COOL switch ON, turn the THERMOSTAT to 300°F (149°C) and allow the oven to cycle for 6 to 8 hours before turning the ON / OFF / OVEN COOL switch OFF.

USING THE GCO2C OVEN

Preheating

1.Close the oven door. Push ON / OFF / OVEN COOL switch ON. The HEAT light will come on, indicating that power to the oven is on.

2.Set THERMOSTAT as desired. Refer to SUGGESTED COOKING GUIDELINES for temperatures and times.

3.Prepare product and place in suitable pans. When READY light comes on, oven has reached desired preheat temperature.

Cooking

1.Open the door and load the product into the oven. Place the pans in the center of racks. Close the door.

2.Set ROAST temperature and time. Set HOLD temperature and GENTLE BAKE time, if desired. GENTLE BAKE time cannot be more than ROAST time. GENTLE BAKE will cycle the fan during the set time at the beginning of the cooking cycle.

3.Press the START/STOP button to start the cooking cycle.

4.At the end of the cooking cycle, the buzzer will sound continuously if the HOLD mode is OFF. If the HOLD mode is ON, there will be a short beep at the beginning of Second Stage Cooking (oven temperature will begin to decline to the HOLD temperature), and a long beep (20 seconds) at the end of the cooking cycle. (Refer to ROAST AND HOLD OPERATION.)

5.When product is done, open the door and carefully remove cooked product from the oven. Wipe up any spills.

End of Day

1.Push ON / OFF / OVEN COOL switch to OVEN COOL. Leave door ajar while the fan is on to cool the oven.

2.When the oven has cooled sufficiently, turn the ON / OFF / OVEN COOL switch OFF and clean the oven.

ERROR MESSAGES — Model GCO2C

E-01 High limit error. Contact Vulcan authorized service.

E-02 Low limit error. Contact Vulcan authorized service.

E-03 High ambient temperature, 215°F (102°C). Contact Vulcan authorized service.

E-04 Low ambient temperature, 32°F (0°C). Let control warm up after cold storage.

E-05 Ignition failure. After trying ignition three times, contact Vulcan authorized service.

E-06 Thermocouple probe open. Contact Vulcan authorized service.

When calling for service, please advise what error code was displayed.

– 13 –