Lincoln Electric LN-10 manual Explanation of Prompting and Error Messages, Display Prompt or Error

B-13 OPERATION B-13

EXPLANATION OF PROMPTING AND ERROR MESSAGES

Display	Prompt or Error
Acc	Displayed on Voltage display, indicates WFS
	display is showing acceleration setting, “1" to
	“5" (See “Acceleration Selection” in this sec-
	tion).
OFF	Displayed on WFS and voltage displays; indi-
	cates limits for WFS or voltage are off for the
	displayed procedure. (See “Maximum and
	Minimum Limits Setting Modes” in this sec-
	tion).
SEC	Displayed on WFS display, indicates Voltage
	display is showing a Timer setting in sec-
	onds. (See “Display Control Keys” in this
	section)
GLP	Displayed on WFS display, indicates that the
	Grounding Lead Protector circuit was activat-
	ed due to excessive current flow into the
	wire feeder frame. When the GLP circuit is
	activated the wire feeder is disabled (the trig-
	ger output to the power source is opened up,
	the motor is stopped, and the gas solenoid is
	turned off). To resume normal operation,
	release the trigger, make sure that the elec-
	trode is not touching the wire feeder frame,
	and then either press a key on the keypad or
	close the trigger. (See “Grounding Lead
	Protector” in this section)
Cld	Displayed on Voltage display when Cold
	Feed Forward or Cold Feed Reverse Key is
	pressed, or Cold Feed Trigger mode is
	selected. Indicates wire is fed “cold” (no
	weld voltage) at the speed indicated on the
	WFS display. (See “Operation Keys” and
	“Trigger Mode Selection” in this section).

---Displayed on Voltage or WFS displays with RUN-IN selected, indicates setting will match those set for Weld Voltage and Wire Feed Speed (See “Display Control Keys” in this section).

HXX	Displayed on WFS display, indicates wire feed over-
	load. XX indicates time remaining in seconds before
	unit resets automatically. (See “Wire Feed Overload
	Protection” in this section and “Avoiding Wire
	Feeding Problems” in the MAINTENANCE section).

Er	EEPROM error. Usually occurs at power-up.
	Indicates one or more of the recalled settings is out
	of acceptable limits. Press any key to return to nor-
	mal operation. Be sure to check all voltage, wire feed
	speed, acceleration and timer settings before you
	proceed.

LN-10