Vulcan-Hart GR45F Removal And Replacement Of Parts, Specifications, Tools, Front Panel, Door

GR SERIES GAS FRYERS - REMOVAL AND REPLACEMENT OF PARTS

SPECIFICATIONS

Electrical

•120VAC supply for Filter-Ready fryers and Kleenscreen filter models only. The filter pump motor draws approximately 5 amps.

Gas Pressures

Manifold (per fryer section):

•Natural - 4" W.C.

•Propane - 10" W.C. Building supply pressure (Min):

•Natural - 5" W.C. (7" W.C. battery units)

•Propane - 11" W.C. (12" W.C. battery units) NOTE: Propane or Natural gases -14" W.C. (Max).

Input BTU Rating

GR SERIES	NO. OF	BTU/HR/SECTION
	TUBES
GR25, GR25F	2	60,000
GR35, GR35F	3	90,000
GR45, GR45F	4	120,000
GR65, GR65F	5	150,000
GR85, GR85F	5	150,000

TOOLS

Standard

•Standard set of hand tools.

•VOM with AC current tester.

NOTE: Any quality VOM with a sensitivity of 20,000 ohms per volt can be used.

•Temperature tester (thermocouple type).

•U-Tube Manometer.

•Pipe joint compound suitable for use with propane gas.

REMOVAL AND REPLACEMENT OF PARTS

FRONT PANEL DOOR

WARNING: DISCONNECT THE

ELECTRICAL POWER TO THE

MACHINE AND FOLLOW LOCKOUT /

TAGOUT PROCEDURES.

1.Open fryer door and remove screws from front panel.

1.Open the fryer door and remove screws securing hinge & door assembly to fryer.

2.Lift front panel from fryer.

3.Reverse procedure to install.

Page 5 of 24 F25125 (March 2003)