GR SERIES GAS FRYERS - REMOVAL AND REPLACEMENT OF PARTS
4.Reverse procedure to install.
MAIN BURNER ORIFICE
WARNING: DISCONNECT THE
ELECTRICAL POWER TO THE
MACHINE AND FOLLOW LOCKOUT /
TAGOUT PROCEDURES.
WARNING: SHUT OFF THE GAS BEFORE SERVICING THE UNIT.
1.Remove main burner orifice from orifice extension.
NOTE: When installing, do not over tighten the orifice or damage to the threads may occur.
GAS COMBINATION VALVE
WARNING: DISCONNECT THE
ELECTRICAL POWER TO THE
MACHINE AND FOLLOW LOCKOUT /
TAGOUT PROCEDURES.
WARNING: SHUT OFF THE GAS BEFORE SERVICING THE UNIT.
WARNING: ALL GAS JOINTS DISTURBED DURING SERVICING MUST BE CHECKED FOR LEAKS. CHECK WITH A SOAP AND WATER SOLUTION (BUBBLES). DO NOT USE AN OPEN FLAME.
NOTE: Gas combination valves are not serviceable and should not be disassembled. Once the problem has been isolated to this control, replace it. Do not attempt to repair the assembly.
1.Remove burners (as necessary) as outlined under MAIN BURNERS.
2.Disconnect lead wires from gas combination valve.
3.On filter ready and Kleenscreen fryers only, remove cotter pin securing handle to gas combination valve on/off knob. Pull handle (with gas combination valve knob bracket attached) away from valve assembly.
4.Disconnect pilot tube.
5.Separate gas line fittings then remove gas combination valve assembly.
2.Reverse procedure to install.
NON FILTER READY SHOWN
NOTE: Remove fittings and piping from gas combination valve and install (in same orientation) on the replacement valve.
F25125 (March 2003) |
| Page 8 of 24 |
|