GBD_GBDF SERIES GAS FRYERS
Quick Start Guide for Solid State Knob Controls with KleenScreen PLUS® Filtration:
Filtering in 6 Easy Steps:
Step 1:
Make sure that the power is on. Do NOT turn off the power to the fryer.
Step 2:
Open the drain valve slowly allowing the oil to drain down into the filter pan. The burners will automatically turn off.
Step 3:
Press FILTER switch to engage the motor / pump. Allow the oil to cycle for a few minutes until the oil and fryer are clean. TIP: Use the provided tank brush to clean and remove food particles from the fry tank.
Step 4: |
|
Close the drain valve slowly allowing the oil to | Drain Valve |
fill the fry tank with clean oil. The burners will |
|
not turn on at this point. Allow the oil to fill back |
|
into the fry tank from the filter pan. It is normal to |
|
see a few air bubbles during this process. |
|
Step 5:
When the filter pan is empty push the FILTER switch to turn off the motor / pump. Oil level should be between the MIN and MAX lines.
Step 6:
Once the level of the oil has been checked and verified, press the START switch. The burners will automatically turn back on and the fryer will resume heating.
