Operation, Filtering Procedure | Vulcan-Hart 2G6BDF, ML-136654

GBD_GBDF SERIES GAS FRYERS

Operation

Hot oil and parts can cause burns. Use care when operating, cleaning and servicing the fryer.

Spilling hot frying compound can cause severe burns. Do not move fryer without draining all frying compound from the tank.

Never run water or boil out solution through filter and motor / pump. Doing so will void your fryer warranty.

FILTERING PROCEDURE

Oil Temperature should be 300-350° F. Use the provided crumb scoop to remove and suspend crumbs on the bottom of the tank before proceeding to Step 1.

1. Do not turn off the Fryer. The power must be on throughout the entire filtering process.

Do NOT heat the fryer during the filtering procedure. Permanent damage to your fry tank may occur and warranty may be voided.

2.Vulcan recommends adding an oil treatment media to the oil prior to filtering.

3.Make sure that the filter drawer is closed completely and that the suction tube and receptacle block are in the correct position. Fig. 5

Fig. 5

VULCAN-HART

F-32934 Rev. B (June 2008)

-21-

Vulcan-Hart 2G6BDF, ML-136654, ML-136656, ML-136657, ML-136681, 4G4BDF Operation, Filtering Procedure

Models: 1G6BD 1G4BD ML-136647 2G8BDF 1G6BD ML-136648 1G8BD ML-136649 1G4BD 2G4BDF 2G6BDF 2XG4BDF 3G4BDF 3G6BDF 2XG8BDF 3G8BDF 4G6BDF 4G8BDF 2XG6BDF 4G4BDF ML-136655 ML-136649 ML-136650 ML-136653 ML-136647 ML-136648 ML-136652 ML-1 ML-136651 ML-136681 ML-136657 ML-136656 ML-136654

Operation

FILTERING PROCEDURE